procedure with no parameters - tabs

1. have a normalized table, wich I convert to denormalized often by left click on proc/run routines()
2. hence the number of opened query tabs builds up enormously (-:

a) no point to put "call proc ()" into new query tab if proc has no parameters.

b)Never understood the sort order of query tabs. It is a mess.
One time query#2 is at start (left top) position next time totaly elsewhere ..... I think these (query tabs) should be ordered as they were created, preseving 'data tab' and such at start of tab list.

also, there is no 'close all query tabs'. And it is needed.

a) where should a procedure and its result be displayed if not in a query tab? There is no other place where HeidiSQL can display a result.

b) The sort order of query tabs is fine, probably you just did not fully get it: All tabs keep their position from when they were created. You have the very first, non-closable query tab (1), and when you open a new one it gets named "#2", then #3, #4 and so on. If you load a file into any query tab its name is renamed to the filename in it. The numbers are still valid, just check it by counting from left to right. I must admit that if you open lots of tabs it tends to get overcrowded. But you should not blame HeidiSQL only for that - you have opened these tabs.

A "close all query tabs" menu could be fine, but I tend to keep rarely used menu items and buttons away from HeidiSQL, to keep it simple.

a)
proc like "procedure()" with no parameters produces nothing, did not check, but I think even if final stuf in it is select sentence it does not spit anything into query resultset box.

b)
sample, clickeq query 3 (set focus) on upper image, and while I had query 10 where it was it wend on total different place.
I think tabs should stay where they are, no need to shift them around when they get focus.

The upper image is actualy nice one, query 10 moves one up, but could be also anywhere else .....

Ah, get it now. Well, that's done automatically by Windows, and it's impossible not to do that when having tabs in more than one row. When you click #3 it has to be highlighted/focused. That happens along with moving the whole tab row into the foreground.